Fixed frame
Camera
This is the footprint value measured perpendicular to the thickness, excluding only the value of the wall and glass rebate fin.
-
Actual example of chamber value of a fixed frame profile
-
Actual example of chamber value of a fixed frame profile with a mortise glass system
If it is a fixed sliding frame, the chamber value is given by the whole height excluding the rebate.
-
Esempio di camera di un telaio fisso per scorrevole
Beat
This is the length of the wall strike flap.
-
Example of a wall-mounted rebate flap
Glass wing
This is the length of the glass rebate flap.
-
Example of glass rebate flap
Glass wing thickness
This is the thickness of the glass rebate fin at the part where the gasket is to be mounted.
-
Example of glass wing thickness
Dente
It is the height of the tooth that has influence on the gut.
-
Tooth example of a fixed frame profile
Note: When calculating the shear length of a traverse or upright Opera also considers the bowing operation for this purpose the height of the profile tooth to which it is to be connected is considered.
Thickness
This is the thickness of the profile measured on the housing side of the glass.
-
Example of profile thickness
Glass cavity
This is the space that must remain between the glass and the profile.
Note: Typically, this is the shim dowel footprint value. This value is considered when calculating the size of the backfill. However, it is important to know that there is a precedence scale that the program takes into consideration when checking the glass gap value, i.e.: the first value to be examined is the one set on the infill, if this is 0(zero) then the one set on the glazing bead will be examined, if this is also 0(zero) then finally the one set on the frame profile (fixed or sash) will be examined.
Sagoma
Report the template code.
Note: Three codes are provided: Z, L, T. Setting the template code correctly can enable the program to tell whether the node you are making is suitable for internal or external openings.
-
Example of a fixed Z-frame
-
Example of a fixed L-shaped frame
-
Example of fixed T-frame
Header angle
Corner composed of the profiles meeting the fixed frame.
Separatore
Sets the profile as a separator.