Profile optimization parameters

From Opera Wiki

(Difference between revisions)
Jump to: navigation, search
Line 27: Line 27:
*'''Type'''[[File:frecciagiu.png]]: the tipe of bar optimization
*'''Type'''[[File:frecciagiu.png]]: the tipe of bar optimization
-
:;'''None''': do not use any optimization on bars
+
**'''None''': do not use any optimization on bars
-
:*'''Interval''': :Choosing this kind of optimization, it’s possible to determine both the minimal and the maximal measure put on disposal by the supplier, and a step of change of the optimization measures. Following this procedure the program draws the best possible measure for the needed bar.
+
**'''Interval''': :Choosing this kind of optimization, it’s possible to determine both the minimal and the maximal measure put on disposal by the supplier, and a step of change of the optimization measures. Following this procedure the program draws the best possible measure for the needed bar.
<!--[[File:taglioott3.png|thumb|right|300px|Esempio di Taglio ottimizzato al pezzo]]-->
<!--[[File:taglioott3.png|thumb|right|300px|Esempio di Taglio ottimizzato al pezzo]]-->
-
:*'''List''':This allows to create a list of maximal measures put on disposal by the supplier. Such measures are analyzed by the program which will take the fittest bar to order in the optimization stage.
+
**'''List''':This allows to create a list of maximal measures put on disposal by the supplier. Such measures are analyzed by the program which will take the fittest bar to order in the optimization stage.
-
:*'''Per part''': This allow to optimize and hence to order the bar, in the real measure of use
+
**'''Per part''': This allow to optimize and hence to order the bar, in the real measure of use
<!-- HELP: JM/W2901 -->
<!-- HELP: JM/W2901 -->
[[Category: JM/Manual]]
[[Category: JM/Manual]]

Revision as of 14:12, 16 May 2011

Optimization parameters
Note N.B: To access this window: from Profiles select Image:tastoottimizza.png button

This window is used to customize the optimization data for a profile.

Content description

  • Min waste: the minimum allowed waste for the profile
  • Min waste offcut: the maximum waste during the optimization of the offcuts
  • Cut priority: sort position for the cutting list
  • Force group bar: if enabled, bars are cut together even when more bars than necessary are required
  • N. of assembled parts: the number of bars to cut together
  • Re-usable leftover: the minimum lenght of the leftover to utilize again
  • Do not divide long pieces: If enabled, long workpieces are not shared out amid the bars to be optimized
  • Unique label pack: If enabled, Opera will print out a unique label for the grouped cut
Note N.B: The following settings are available only when Opera Smart Optimization is installed
  • TypeFile:frecciagiu.png: the tipe of bar optimization
    • None: do not use any optimization on bars
    • Interval: :Choosing this kind of optimization, it’s possible to determine both the minimal and the maximal measure put on disposal by the supplier, and a step of change of the optimization measures. Following this procedure the program draws the best possible measure for the needed bar.
    • List:This allows to create a list of maximal measures put on disposal by the supplier. Such measures are analyzed by the program which will take the fittest bar to order in the optimization stage.
    • Per part: This allow to optimize and hence to order the bar, in the real measure of use
Personal tools