Profile optimization parameters

From Opera Wiki

Optimization parameters

N.B: To access this window: from Profiles select button

This window is used to customize the optimization data for a profile.

Content description

• Min waste: the minimum allowed waste for the profile
• Min waste offcut: the maximum waste during the optimization of the offcuts
• Cut priority: sort position for the cutting list
• Force group bar: if enabled, bars are cut together even when more bars than necessary are required
• N. of assembled parts: the number of bars to cut together
• Re-usable leftover: the minimum lenght of the leftover to utilize again
• Do not divide long pieces: If enabled, long workpieces are not shared out amid the bars to be optimized
• Unique label pack: If enabled, Opera will print out a unique label for the grouped cut

N.B: The following settings are available only when Opera Smart Optimization is installed

• Type: the tipe of bar optimization

None

do not use any optimization on bars

• Interval: :Choosing this kind of optimization, it’s possible to determine both the minimal and the maximal measure put on disposal by the supplier, and a step of change of the optimization measures. Following this procedure the program draws the best possible measure for the needed bar.
• List:This allows to create a list of maximal measures put on disposal by the supplier. Such measures are analyzed by the program which will take the fittest bar to order in the optimization stage.

• Per part: This allow to optimize and hence to order the bar, in the real measure of use