Waste management: % recycle of offcuts

From Opera Wiki

work in progress

N.B: In order to introduce the management of the scrap it is opportune to clarify some basic concepts: we define WASTE the part of advanced profile in phase of cut.

N.B:' In Opera Job Management, the waste can be reused (and it is called PIECE) or it will be lost. The reuse of the pieces is linked to the cutting settings defined in the program: for example, by establishing a minimum cut size of 500 mm, during the optimization phase the program will take into account the larger parts of that measure.

N.B: Another important concept concerns the definition of WASTE': in Opera Job Management defines the part of profile or piece that will not be considered for the purpose of cutting optimization. By setting a minimum scrap to 50 mm, the optimization will be performed considering that from the length of the profile in question should be excluded 50 mm.

% reuse of pieces: the new section is important for the calculation of order costs, because it allows you to set the percentage of reusable waste that you plan to use on average for your production. The programme will use this percentage in two circumstances:

• in the order material analysis, to estimate the amount of discarded profiles, evaluating their impact on the total cost of the same.
• in the cutting optimization, instead, the evaluation will be made in percentage on the length of the profiles, per single bar.

Process

First of all, it is necessary to indicate in Opera what is the size of a bar considered usable (Minimum piece).
This parameter can be set by going to the menu Workshop > Cutting'.

File:Spezzoneminimo.png

In the section % reuse of pieces, please indicate the percentage of pieces that are expected to be reusable.

File:Per utilizzo spezzoni.png