How to multiply structures

From Opera Wiki

Jump to: navigation, search
File:Quadroparametrimoltiplicazione.png
The framework of multiplication parameters
Note N.B: To access this pane in Opera Job Management: from the design sheet of a type, press the File:Motiplica.png

Below are the contents of the framework:

The Upright Section

  • Montante File:tastoc.png: It is the code of the upright profile to be used in common between structures.
  • Tipo inserimentoFile:tastomenutendina.png: In this box the operator has the option of determining how the upright is to be inserted, i.e., whether it is to be inserted as a double profile or whether the profile is to reach all the way to the ground.
  • Montanti : In this box the operator will enter the amount of mounts within the type.

The Traverse Section

  • Traverso File:tastoc.png: It is the code of the transverse profile to be used in common between structures.
  • Tipo inserimento File:tastomenutendina.png: In this box the operator has the option of determining how the traverse is to be inserted, that is, whether it is to be inserted as a double profile or whether the profile is to reach all the way to the wall.
  • Traversi : In this box the operator will enter the amount of stringers within the typology.

The Quote section

  • Quota base , Quota superiore: These are the dimensions of the transom in reference to the lower and upper widths. By entering values in these boxes, the program will consider the traverse as the base of the type or as the upper width by eliminating previously placed profiles.
Personal tools