Plinth reported
From Opera Wiki
Contents |
Camera
This is the footprint value of the profile.
Zoccolorip.png
Example of a plinth chamber reported |
Glass wing
This is the length of the glass rebate flap.
Glass wing thickness
This is the thickness of the glass rebate fin at the part where the gasket is to be mounted.
Zoccolorip2.png
Example of glass wing thickness of a plinth reported |
Dente
It is the height of the tooth that has influence on the gut.
Incastro
And the part of the profile that is attached to the frame profile.
Zoccolorip3.png
Example of the embedding thickness of a plinth carried over |
Thickness
This is the thickness of the profile measured on the housing side of the glass.
Zoccolorip4.png
Example of the thickness of a plinth reported |
Intesta a
It tells the program that it should consider the value set in the Header box.
N.B: The addition value related to heading is normally that of the profile tooth to which the profile to be headed is to be connected. However, it is possible to indicate to the program that it should consider another addition value that is, the one set in the Header box.Header
It is the profile elongation value for the bowing operation.
N.B: This value is considered only if the box Headed to has been activated.
Header angle
Corner composed of the profiles meeting the fixed frame.
Glass cavity
This is the space that must remain between the glass and the profile.
N.B: Typically, this is the shim dowel footprint value. This value is considered when calculating the size of the backfill. However, it is important to know that there is a precedence scale that the program takes into consideration when checking the glass gap value, i.e.: the first value to be examined is the one set on the infill, if this is 0(zero) then the one set on the glazing bead will be examined, if this is also 0(zero) then finally the one set on the frame profile (fixed or sash) will be examined.
Application type
Field to specify which profile application (All, Frame, Sash).
