Plinth

From Opera Wiki

Camera

This is the footprint value measured perpendicular to the thickness, excluding only the value of the glass rebate flap.

Beat

This is the length of the strike flap.

Glass wing

This is the length of the glass rebate flap.

Glass wing thickness

This is the thickness of the glass rebate fin at the part where the gasket is to be mounted.

Dente

It is the height of the tooth that has influence on the gut.

Thickness

This is the thickness of the profile measured on the housing side of the glass.

Intesta a

It tells the program to consider the value set in the intest box.

N.B: The addition value related to heading is normally that of the profile tooth to which the profile to be headed is to be connected. However, it is possible to indicate to the program that it should consider another addition value that is, the one set in the intest box.

Header

It is the profile elongation value for the bowing operation.

N.B: This value is considered only if the box Headed to has been activated.

Header angle

Corner composed of the profiles meeting the fixed frame.

Enable V-cut

Indicates that V-cutting is performed in this profile.

Glass cavity

This is the space that must remain between the glass and the profile.

N.B: Typically, this is the shim dowel footprint value. This value is considered when calculating the size of the backfill. However, it is important to know that there is a precedence scale that the program takes into consideration when checking the glass gap value, i.e.: the first value to be examined is the one set on the infill, if this is 0(zero) then the one set on the glazing bead will be examined, if this is also 0(zero) then finally the one set on the frame profile (fixed or sash) will be examined.

Dist. min. ruler (Dist. min. ruler)

Minimum distance of the ruler from the wall.

Sagoma

Report the template code.

N.B: During the phase of assigning the baseboard to the type if the template code is T and the sub-baseboard will not also be added, the program will issue the error message "An inconsistency was detected in the rebates of the mobile frame profiles. Probable opening impossible," see theAppendix III: the variables and symbols for explanation and solution of this problem.

Type M/T

Field to filter the selection related to the use of the type of upright/traverse (All, Upright, Traverse).

Application type

Field to specify which profile application (All, Frame, Sash).

Complanarity

The function of this box, and directed to the creation of nodes. For profiles that have a coplanarity, such as between the frame and sash, by entering the value in this box, when the program detects the profile image in the Node Creation Box, it takes this value into account, placing the sections with the coplanarity value.

Offset M/T

Displacement of the mullion/crossbar elevation from the profile axis.

Separator

Sets the profile as a separator.

Asymmetrical

The profile is considered asymmetrical with respect to the inner and outer surfaces.

Glass cavity #2

It is triggered by the use of the previous field to determine the lower glass gap height for asymmetrical mullions/ transoms.

Intercapedine

This is the space between the floor and the baseboard profile.