Lyna.Ferhi: Created page with '=== Camera === This is the footprint value of the profile. File:zoccolorip.png|Example of a plinth chamber reported === Glass wing === This is the length …'

2024-09-26T18:31:36Z

Created page with '=== Camera === This is the footprint value of the profile. <gallery> File:zoccolorip.png|Example of a plinth chamber reported </gallery> === Glass wing === This is the length …'

New page

=== Camera ===

This is the footprint value of the profile.
<gallery>
File:zoccolorip.png|Example of a plinth chamber reported
</gallery>

=== Glass wing ===

This is the length of the glass rebate flap.

=== Glass wing thickness ===

This is the thickness of the glass rebate fin at the part where the gasket is to be mounted.
<gallery>
File:zoccolorip2.png|Example of glass wing thickness of a plinth reported
</gallery>

=== Dente ===

It is the height of the tooth that has influence on the gut.

=== Incastro ===

And the part of the profile that is attached to the frame profile.
<gallery>
File:zoccolorip3.png|Example of the embedding thickness of a plinth carried over
</gallery>

=== Thickness ===

This is the thickness of the profile measured on the housing side of the glass.
<gallery>
File:zoccolorip4.png|Example of the thickness of a plinth reported
</gallery>

=== Intesta a ===
It tells the program that it should consider the value set in the '''Header''' box.
{{NB|The addition value related to heading is normally that of the profile tooth to which the profile to be headed is to be connected. However, it is possible to indicate to the program that it should consider '''another addition value''' that is, the one set in the '''Header''' box.}}

=== Header ===
It is the profile elongation value for the bowing operation.
{{NB|This value is considered only if the box '''Headed to''' has been activated.}}

===Header angle===
Corner composed of the profiles meeting the fixed frame.

=== Glass cavity ===
This is the space that must remain between the glass and the profile.
{{NB|Typically, this is the shim dowel footprint value. This value is considered when calculating the size of the backfill. However, it is important to know that there is a precedence scale that the program takes into consideration when checking the glass gap value, i.e.: the first value to be examined is the one set on the infill, if this is 0(zero) then the one set on the glazing bead will be examined, if this is also 0(zero) then finally the one set on the frame profile (fixed or sash) will be examined.}}

=== Application type ===
Field to specify which profile application (''All'', ''Frame'', ''Sash'').

Plinth reported - Revision history

Lyna.Ferhi: Created page with '=== Camera === This is the footprint value of the profile. File:zoccolorip.png|Example of a plinth chamber reported === Glass wing === This is the length …'