Lyna.Ferhi: Created page with 'L'archivio ITT {{NB|To access this box in Opera Job Management: from the ''Regulations'' menu, select ''ITT''.}} This ar…'

2024-07-05T17:09:37Z

Created page with 'L'archivio ITT {{NB|To access this box in Opera Job Management: from the ''Regulations'' menu, select ''ITT''.}} This ar…'

New page

[[Image:finestraarchiviocertificazioni.png|thumb|500px|L'archivio ITT]]
{{NB|To access this box in Opera Job Management: from the ''Regulations'' menu, select ''ITT''.}}

This archive groups all the certificates associated with your windows and doors. Listed below are the basic steps to be able to enter a new certificate:
# From the filter at the top, select System and Series to which the certificate you want to enter refers
# Click on [[Image:tastopiu.png|25px]] to add a new certificate
# Pressing the [[Image:keyomenutendina.png]] button at the ''Type'' field will allow you to choose the type of the certificate you are going to enter (e.g., Thermal Series, Thermal Node...). Each certificate has different data to be loaded: depending on the type chosen, only the useful entries to be loaded will be activated, while the others will be grayed out. For node thermal after entering System, Series and Node, you will also have to write the Uf Value present in the certificate.
# Also carefully enter the Certificate number, date and the'''full address''' of the laboratory that did the testing, as this is essential data in order to use the certificate
# The button [[Image:keydocuments.png]] at the bottom allows you to enter the PDF document attachment to be associated with the certificate
# The button [[image:tastonodi2.png]] opens the [[Series Certification Node Archive]] and allows the node to be matched with a certificate for transmittance calculation even if the node is not saved in the archive. Once matched, the following key will be shown [[image:keyvisualizecertificate.png]] ([[Opera Job Management#Opera_JM_3.7|Available from version 3.7]])
# Once all the required data has been entered, press the [[Image:keyoregistra.png]] button to save the entered data.
The most important data for uploading an '''AAV(Water/Air/Wind) certificate,''' are as follows:
* System, Series, and Name of type of interest
* Class values (air permeability, water resistance and wind load resistance)
* Sample width and height.

Remember that all active fields must '''always'' be filled in.


[[Category: CE/Manuale]]

ITT - Revision history

Lyna.Ferhi: Created page with 'L'archivio ITT {{NB|To access this box in Opera Job Management: from the ''Regulations'' menu, select ''ITT''.}} This ar…'