View source

=== Camera ===

This is the footprint value of the profile.


Example of a room of a door frame carry back and forth


=== Beat ===

This is the length of the strike flap.


Example of rebate of a balance frame carryover

Glass wing
This is the length of the glass rebate flap.

Sp ala vetro
This is the thickness of the glass rebate fin at the part where the gasket is to be mounted.

Dente
It is the height of the tooth that has influence on the gut.

Incastro
This is the part of the profile that remains after excluding the stop and chamber.


Example of the interlocking value of a balance frame carryover

Z «-» T
Indicates that it will turn the profile to which it is connected into T or vice versa.

Thickness
This is the thickness of the profile measured on the housing side of the glass.

Intesta a
Indicates to the program that it should consider the value set in the intest box. 
The addition value related to heading is normally that of the profile tooth to which the profile to be headed is to be connected. However, it is possible to indicate to the program that it should consider another addition value i.e., the one set in the intest box.

intestinal
It is the profile elongation value for the bowing operation.
This value is considered only if the Header to box has been activated.

Interc
This is the distance between one profile and the other measured from the beginning of the chamber of one to the beginning of the chamber of the other.


Example of the gap of a door frame carryover to and fro

Interc glass
This is the space that must remain between the glass and the profile. 
This is usually the space value of the shim dowels. This value is considered when calculating the size of the filler. However, it is important to know that there is a precedence scale that the program takes into account when checking the glass gap value, i.e.: the first value to be examined is the one set on the infill, if this is 0(zero) then the one set on the glazing bead will be examined, if this is also 0(zero) then finally the one set on the frame profile (fixed or sash) will be examined.